When extracting the zip file, the following error message appeared, as shown in the picture. It was unpacked with SpeedCommander V.20 Pro 64Bit under WIN11 64Bit.
I then tried it with Windows Explorer and there were no problems.
Legend 1.4.3 zip File ErrorModerators: Christophe, Mark
6 posts
• Page 1 of 1
Legend 1.4.3 zip File ErrorYou do not have the required permissions to view the files attached to this post.
Re: Legend 1.4.3 zip File ErrorI just downloaded the zip file again and it unzips fine with Window's built in utility. With 7-Zip it unzips fine but gives the following message:
Not sure what "some data after the end" means as I normally only use 7-Zip to open .rar archives. I don't see much point in using anything but the Windows built in utility to open common zip files. You do not have the required permissions to view the files attached to this post.
Re: Legend 1.4.3 zip File ErrorWinRAR, 7-Zip and Windows 10's Explorer (built-in) extracted with no errors or warnings.
SoundCloud ::: Facebook
Re: Legend 1.4.3 zip File ErrorI wonder why 7-Zip would give two different results? Could be because I'm using an old version from 2019.
Re: Legend 1.4.3 zip File ErrorWe zip with older tools to maximize compatibility, but there may still be tools that do not fully support all zip variants.
Generally speaking, unzipping via OS should always work. Admin - Synapse Audio Software
Twitter - www.twitter.com/SynapseAudio Facebook - www.facebook.com/SynapseAudioOfficial
Re: Legend 1.4.3 zip File ErrorI've always used WinRar, didn't even know windows had its own zip app
Windows 11 Home - 12th Gen Intel(R) Core(TM) i5-12400 2.50 GHz -32GB RAM
250GB SSD - 1TB HDD | M-Audio Oxygen 25 V
6 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 436 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |