One thing I found alarming with Screamer is when using Scale Velocities. I had a pattern I wanted to go from 128 to 50 like a fade out. After I performed the task, the first two or three notes were this deep blue colour. Checking their velocity values, one said 129 and the other was 135! Easy enough to correct by hand, but thought it might be of interest to check on and look into,
The other is it seems to get cut after a pitch bend returning to 0 and a sustained note. Sometimes it plays back smoothly, sometimes there's this hic-up when the 0 level hits.
A couple of things with Screamer...Moderators: Christophe, Mark
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 168 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |