The behaviour of the high band seems a bit strange. I have tested this by running white noise through and sweeping the band position. This is what I expect and was done in Renoise with the multiband tool with the high band sweeping down from 22 kHz.
With Orion I used the band control like this:
I tried to automate the high band but this did not work (the low band can be automated though) so had to do a sweep with my mouse so it is not very smooth.
This starts at the top 8000 Hz and sweeps down. Two observations are that from 8000 - 7000 the spectrum plot is darker for all frequencies. At around 7000 Hz there is a dead spot.
As an aside the BandFX is great when used for multiband compression with the excellent CV-82. It would be nice if there were solo buttons for each band to make it easier to identify the ranges.
BandFX Control Bug?Moderators: Christophe, Mark
1 post
• Page 1 of 1
1 post
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 260 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |