i got some problem i couldnt figure out even reading the manual!

when i set the OSC 1 volume to the amount here on the pic with the yellow bar and then let it modulate from lfo1 with +54 amount does it mean that +54 is from 0 to the set amount of the volume in the OSC1 mixer or the whole range of OSC1 even over the limit i set of OSC1? like 54% from 0-100 or about 50-100?

## Dune 2 Mod Matrix Amount question
5 posts
• Page
1 of 1
## Re: Dune 2 Mod Matrix Amount question
current value of source (which has been ranged [0,+1] if unipolar or [-0.5,+0.5] is multiplied the mod matrix amount value You do not have the required permissions to view the files attached to this post.
- jk-d2
- Novice
**Posts:**38**Joined:**Wed Dec 31, 2014 10:38 am
## Re: Dune 2 Mod Matrix Amount questionForgive me for sounding stupid but when the mod matrix has a source of 'LFO1' then what actual value does it relate to ? Is it the rate of the lfo or the amount of the lfo? Or is it the value of the waveform ? I just tested, and it is the waveform transformed into a number. Sines go smoother than those saws.
- jk-d2
- Novice
**Posts:**38**Joined:**Wed Dec 31, 2014 10:38 am
## Re: Dune 2 Mod Matrix Amount questionLFO is bipolar [-0.5,+0.5]
Osc 1 level is 50% so max waveform number (the waveform transformed into a number) is +0.5 So current value in mod matrix of 'LFO1' then is +0.5, so that value is multiplied with the amount value in the mod matrix (+54) So, +0.5 x 54 is 27 So when the sinewave of the LFO is at it's biggest (I suppose the level of that curve of the wave, the amplitude of the wave) the volume of the Osc 1 level will be 27 or half of the knob value. Is this correct? Logically you can't have a value bigger than the OSC1 level max level (100%) - jk-d2
- Novice
**Posts:**38**Joined:**Wed Dec 31, 2014 10:38 am
## Re: Dune 2 Mod Matrix Amount questionThis 27 is then added to the 50% of the osc 1 value , I think. So the volume of osc 1 becomes 50+27 = 77.
- jk-d2
- Novice
**Posts:**38**Joined:**Wed Dec 31, 2014 10:38 am
5 posts
• Page
1 of 1
## Who is onlineUsers browsing this forum: No registered users and 6 guests |

© 2017 Synapse Audio Software. All Rights Reserved. |