I was wondering if someone could provide me with any advice on how to simulate analog behavior in Dune3 such as oscillator drift and random keytracking, similar to what is seen in the Legend.
In most cases, I modify the oscillator fine pitch by using a slow LFO in polymode that is equipped with S&G. Generally speaking, it sounds better with chords if the offset is set off center. I'm not sure what the offset is, but it's generally off center.
Although it is possible to detune and disperse the different voices inside a chord in the Legend, I am not certain whether this is something that can be done with Dune3.
Emulate analog behavior with Dune3Moderators: Christophe, Mark
2 posts
• Page 1 of 1
Re: Emulate analog behavior with Dune3Analog oscillators don't really "drift" once they come up to temperature, unless you're in some sort of wild environment where the temperature is wildly fluctuating. What is common is that each voice card is slightly off due to differences in components and calibrations. If you want to use Dune 3 to get this effect (it's totally possible), just read this website and apply what you learn on Dune.
https://www.voicecomponentmodeling.com/ Using the voice parameters in the mod matrix is especially useful. The parameters I find most useful to modulate are pitch, cutoff, resonance and filter and amp envelope adsr values.
2 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 195 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |