saturation effect VSTModerators: Christophe, Mark
8 posts
• Page 1 of 1
saturation effect VSTI wish Orion saturation effect run by VST on Cubase , acid etcÂ
saturation effect VSTOnly one saturator that I can see.
Insert -> FX Misc -> Saturation. SoundCloud ::: Facebook
saturation effect VSTi don't see any problem if you have already bought orion you don't need to spend 500$ :
load orion drag and drop your track inside orion (can't be easier !) insert the fx saturation set the right bpm set your end loop marker stream to wave (24/32 bit if necessary) job done btw what host are you using ? Yamaha CS-30, Roland SH-1, Roland MKS70, Focusrite Scarlett 18i6, Yamaha FS1R, Oberheim Matrix 1000, Novation Remote 37SL, Korg Legacy, Alesis M1Active 520, Novation Launchpad Pro, Push2, Intel i7-7700HQ
saturation effect VSTYes, and there is always rewire which I assume might be used to pull this off also.
saturation effect VSTOnly using instruments tracks on orion , there's no problems.
of course insert the saturator master section. But sometimes I have to mix down the songs including vocals and some chorus parts. and I have to write the Vocal volume automation for the mixdown. At the case, I use Cubase . On Orion , writing volume automation is very hard! even if using rewire cubase and orion, Vocals part (in cubase) is not effected saturations(rewired orion). So I wish that I can insert the orion saturator in cubase master section!
saturation effect VSTIn that case: maybe you should write Richard directly and try to persuade him into porting the native fx into vst. I don't know the likelyhood of that happening: but you might as well give it a shoot.
Good luck!
saturation effect VSTIt's too bad Fat Ass VST's are defunct now. But if you search Google, some of their things still pop up at other places. But they were really good IMHO. And there must be other comperable saturator VSTs like OP's out there to choose from. But once you get used to the simplictiy and ease of that OP effect, why would one want anything else.
Why would writing down OP volume automation be so hard H-K? Do you have to do it on per measure basis, or quadrant like? Don't forget you can also hover/click over the volume fader and get updated db level before and after automation moves. Last edited by Dungeon Studio on Thu Apr 01, 2010 2:44 am, edited 1 time in total.
8 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 368 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |