I can't seem to make LFO run independently of key pressed (free-running), it resets every time. How can you do that?
It would help me make some sick arpeggiated lines, but so far I cna use LFO only on pads and sustained sounds :/
How to stop LFO from resetting on note pressModerators: Christophe, Mark
4 posts
• Page 1 of 1
Re: How to stop LFO from resetting on note pressIn the Mod Matrix try Const -100 LFO Init Phase. If that doesn't do what you want try different sources to LFO Init Phase.
The manual says........... By default LFOs operate in a global fashion, ie all voice destinations receive the same LFO signal. When the POLY switch is enabled, however, each voice uses its own, local LFO. This allows to set up modulations which always start at zero phase, for instance. So try turning off Poly. This question has come up before and to be honest I don't remember what the solution is at the moment. Someone else will response I'm sure.
Re: How to stop LFO from resetting on note pressIf I understand you correctly then putting the LFO in poly mode and adding {Random +100 LFO Init phase} to the mod matrix will hopefully get you closer to where you want to be.
Re: How to stop LFO from resetting on note pressThank you. How about MSEGs then?
4 posts
• Page 1 of 1
Return to Plugin Support (VST/AU) Who is onlineUsers browsing this forum: No registered users and 543 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |