This must have been mentioned before,but here goes anyway...
I love DUNE 3 but there are a few design choices that really baffle me...
The first two are what I have been banging on about since it was released...
It needs increased polyphony and for the oscillators to be able to be independently assigned to each filter...
Fair enough...I have a feeling that those features might just turn up very soon...
But there is another design choice that just doesn't make sense to me...
The FX in DUNE 3 are great,but you can sync the reverb and not the chorus ! ?
You can sync the flanger,but the chorus is left to wobble along in it's own orbit...
Maybe this was a genuine mistake and the reverb sync assign was meant to be for the chorus ?
I hope that this can be sorted out in a later update because this design choice seems a little strange...
If I could move the sync button from the reverb to the chorus,I would have done it yesterday
DUNE 3 - No Chorus Sync !Moderators: Christophe, Mark
3 posts
• Page 1 of 1
Re: DUNE 3 - No Chorus Sync !A sync effect for the chorus would be nice, but you can also make a passable chorus effect with one or both of the delay modules.
Use a synced LFO to modulate the delay time (short delay times) a small amount. Turn down feedback and set dry/wet to 50/50.
Re: DUNE 3 - No Chorus Sync !I understand...
But it makes much more sense to take the sync control off the reverb and glue it on to the chorus instead
3 posts
• Page 1 of 1
Return to Plugin Support (VST/AU) Who is onlineUsers browsing this forum: No registered users and 519 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |