Hello everyone,
I am searching for the Phase knob but I can't find them.
Does Dune3 have a Phase knob?
The best,
YJoo
Moderators: Christophe, Mark
Reset
When reset is enabled, the oscillator will always start at the zero phase when a new key is pressed.
When disabled, the oscillator starts with a random initial phase. A specific phase angle to start
with can be set within the modulation matrix.
Osc Init Phase
This parameter sets the absolute starting phase of the oscillator whenever a note is triggered.
As a consequence, it will no longer be in free-run mode. Set to zero, the specified oscillators
starts at zero phase. An amount of +50 corresponds to a +180 degree phase shift, an amount
of +100 to +360 degrees, etc. While the human hearing is largely insensitive to the starting phase
of a single oscillator, the relative phase difference between both oscillators can matter in some
cases, for example when both oscillators share the exact same frequency.
Return to Plugin Support (VST/AU)
Users browsing this forum: No registered users and 455 guests