Detuning and pitch in DUNE 2

by **Mark** » Thu Mar 26, 2015 10:59 am

I've already measured it

by **Richard** » Thu Mar 26, 2015 9:14 pm

Yorrrrrr wrote:Today I noticed something. If I have OSC 1 and 2 active and I try to detune one of them with the FINE knob by +1 cent (up to +3), I don't hear (or see in an spectrogram) any phasing effect or movement.

The knob is scaled such that you can go from very subtle detuning to strong detuning. This is a rather common practice, the Supersaw is a prime example of this, or the DX7 tuning options.

by **Yorrrrrr** » Thu Mar 26, 2015 9:17 pm

Oh, I see. It is then awesome to have the option of using a finer detune than in the rest of synths available. Thanks Richard.

But.. the popup readout when I add "1.0 ct" in OSC FINE knob...is it really 1 musical cent?. Is this accurate?

What about the OSC Fine mod matrix destination that uses a range of 4 semitones instead of 1 (as in the OSC Fine knob)?

by **Teksonik** » Thu Mar 26, 2015 11:15 pm

Mark wrote:I've already measured it

That's getting a little too personal :shock:

Ohhh you mean the Detune....sorry............. :oops:

by **Mark** » Fri Mar 27, 2015 8:22 am

Yes, I measured the output from twiddling with the knob :lol:

Basically, as Rich says, if you only move it a bit then not much happens, but it does get bigger the more you move it. :music:

by **heks** » Fri Mar 27, 2015 9:42 am

Mark wrote:Yes, I measured the output from twiddling with the knob

Basically, as Rich says, if you only move it a bit then not much happens, but it does get bigger the more you move it.

Uooo, , errr , , carry on matron,,, , , , I mean Mark . :lol: