Is there an ARP On/Off?

[EnjoyRC]

Is there an ARP On/Off? If there is, can it be automated?

Side question: Where is the search on this forum? I've looked all over the page. It's hidden.

[Richard]

Yes, the Arp On/off is located on the right in the Common section. There is two buttons, one for each arpeggiator and voice. And yes Arp On/Off can be automated via your host sequencer.

About search, click on a username to search for posts, alternatively try this link:
search.php

[EnjoyRC]

Yes, the Arp On/off is located on the right in the Common section. There is two buttons, one for each arpeggiator and voice. And yes Arp On/Off can be automated via your host sequencer.

Ahhh... there they are. Thanx

[basemaker]

Hi,
The ARP 1/2 ON/OFF Buttons doesn't seem to function as they should.
058 PD Lofty PAd PD has Step Seq running, but ARP 1 or ARP 2 Button are not illuminated.
I was trying to stop Step Seq from running in this preset and clicked the ALL Button and then on the ARP 1 Button so that it is lit and clicked it again, after that the Seq stopped, where is the Logic, please? Clicking on ARP 2 Button the Seq stops too, no logic behaviour?

[Kriminal]

run thru each layer to see which one is using the ARP

[basemaker]

ok, thanks a lot, found it.