I think this movie shows everything best:
http://io2o.com/TSlideBug.avi
T-Slide GUI bugModerators: Christophe, Mark
4 posts
• Page 1 of 1
T-Slide GUI bugI don't see any bug in there.
The first T-slide example is set to 2 semitones and when you expand the PB to 12 semitones the T-slide is still where you put it at 2 Semitones. It is the pb range that has been higher since you expanded that range from 2 to 12 Example 2 is also correct since you have Made a T-Slide with 12 Semitones and then changed the PB Range down to 2 Semitones. So there you have drawn the T-slide outside of the PB 2 Range.
T-Slide GUI bugMaby it is not bug bug, but only there are no refresh after PB range change. Just it and I know - it works as schould. Just it.
T-Slide GUI bugI've noticed this too, it's the same with the Pitch. Seem to be a minor PB meter gui refresh problem.
4 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 201 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |