DUNE: "Pitch" 1 octave instead of 2 tones?Moderators: Christophe, Mark
6 posts
• Page 1 of 1
Re: DUNE: "Pitch" 1 octave instead of 2 tones?Click on the two (for both pitch up and down) and drag your mouse until it says 12. Note that this is global, so will affect all your patches
Re: DUNE: "Pitch" 1 octave instead of 2 tones?Hmmm never really noticed this was Global before as I usually leave Pitch Bend at +-2 but it really should be saved with each patch rather than Global...........looks like the setting is stored within each bank file...........
Re: DUNE: "Pitch" 1 octave instead of 2 tones?You could, of course, use PWheel as a source in the mod matrix and set pitch semi as destination. Set global pitch wheel assignment to zero. That way different patches can have different pitch bends.
Re: DUNE: "Pitch" 1 octave instead of 2 tones?That's a good idea.........
Edit: Ooooh and you can then tune each Osc to a different Pitch Bend although I'm not sure if I'd ever want to.....or tune each of the 8 layers differently using Voice Number........ I pretty much just stick with +-2 for leads and such........
Re: DUNE: "Pitch" 1 octave instead of 2 tones?You might get some nice sync effects if you did that with sync'd oscillators. FM might be worth experimenting with too.
6 posts
• Page 1 of 1
Return to Plugin Support (VST/AU) Who is onlineUsers browsing this forum: No registered users and 308 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |