Hi, I was wondering if there is any way for the coarse tune parameter to have a half-tone incremental scale instead of continuously adjustable frequency? That would be so handy...
kind greets
EKS Pro tuning questionModerators: Christophe, Mark
6 posts
• Page 1 of 1
Re: EKS Pro tuning questionActually my question should have been: where can I find the manual for the EKS Pro?
Re: EKS Pro tuning questionThe manual is there to where you have installed your EKS Pro (e.g your VST plugin folder). On Windows its link is at the Start menu too at the Synapse Audio stuff.
For semitone tuning you may switch EKS Pro into pitchable mode (set "KTRK OFF" off at the OUT section).
Re: EKS Pro tuning questionFound it, thanks!
Re: EKS Pro tuning questionDude
Find yourself a Frequency chart showing freq sets for each note. oh - heres one http://www.phy.mtu.edu/~suits/notefreqs.html Dont Freq Out Man ---=u f o=--- /Radiation Mutant / Snee-Nee-Iq
Re: EKS Pro tuning question
Thanks for your reply mr ufo, but that won't be necessary: as long as you have keytracking set up properly and the coarse tune knob to either -12/0/+12, the EKS will track the incoming midi pitch perfectly ! It's easier to check if keytracking is correct if you kill the pitch sweep (no LFO or env amt) and set a long decay/sustain and play some notes higher up the keyboard than you normally would feed the synth for kicks.
6 posts
• Page 1 of 1
Return to Plugin Support (VST/AU) Who is onlineUsers browsing this forum: No registered users and 494 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |