I am new to DUNE, but have worked with other synths before so I get *most* of how DUNE works, but I am stuck on how to assign individual parameters to a specific voice.
The manual says that up to 8 voices can be used in a patch and that each voice can use entirely different parameters. This sounds awesome, but I don't know where to assign the main parameters to an individual voice as opposed to the whole patch.
Any help with this would be hugely appreciated because this is one of the reasons I bought DUNE: to make rich, complex sounds.
Thanks!
Louis
RE: Individual Voice Editing??Moderators: Christophe, Mark
2 posts
• Page 1 of 1
Re: RE: Individual Voice Editing??Oh, OK, I think I just answered my own question.
It appears that each voice is accessible individually in the modulation matrix, and there is a parameter called a "constant" that can be used to assign a specific knob value to a particular parameter of an individual voice to make that parameter of the voice different from the main knob values for the entire patch. Correct? (I'm not at home at the moment so I can't test it out...) So, now it looks like the only limitation is that there are only 24 values that can be set in total. Might want to bump this up in future releases of DUNE, because I can already think of ways to use all 24 channels. =) Thanks again! Louis
2 posts
• Page 1 of 1
Return to Plugin Support (VST/AU) Who is onlineUsers browsing this forum: No registered users and 461 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |