I created a topic that decribes a bug when modulating the wavetable index at a high speed ( arp set to hertz and arp mode mode set to slient )
ARP MODE NEEDS TO BE SET TO SILENT
It seems that this bug is present when modulating any parameter
Choose arp velocity as modulator
Set arp mode to silent
Choose hertz as speed , (high )
Modulate any parameter
Turn of arp ..
Result , some nasty modulation is still going on .
arp modulating ---> any parameter (high speed hertz )Moderators: Christophe, Mark
4 posts
• Page 1 of 1
Re: arp modulating ---> any parameter (high speed hertz )Hi Richard can you confirm this bug ?
Re: arp modulating ---> any parameter (high speed hertz )I couldn't replicate it. Can you upload a preset.
Re: arp modulating ---> any parameter (high speed hertz )The bug dissapears when the program is saved .
It's the exact same bug as described in the 'modulate wavetable bug ' , that one is reproducable ..so this one should be to. The 'silent ' arp mode and high speed Hz mode are the problem . Steps to reproduce . Initialize dune . -Set al osc mixing faders to 0 -matrix arp velocity ---> osc 1 volume ...amount 100% -set arp mode to ' silent -set arp mode to Hz (sync off ) and select highest freq 100z -program some velocities -activate arp . PLAY a note Now the arp is modulating the osc . amp at a high speed range ... -Now disable arp ... PLay a note , result : there is still some nasty modualtion going on
4 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 368 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |