Open any instrument,open the piano roll, show automation events and choose any parameter from the combobox, switch to bar automation and do a single left click in the middle of the automation sub-window.
You will see some bars drawed, TO THE LEFT where you clicked, while the right half would be at zero. It should be reversed, and if you switch between bars automation and normal automation events you will see how normal automation show the right curve.
It doesn't matter how do you play this pattern, the parameter will follow the normal automation
Orion 8.5 PB: Bars automation issueModerators: Christophe, Mark
4 posts
• Page 1 of 1
Orion 8.5 PB: Bars automation issueYou do not have the required permissions to view the files attached to this post.
Re: Orion 8.5 PB: Bars automation issueConfirmed here. Well spotted ! If Rich or Marcin doesn't see this I'll post it at the Beta Forums....
Re: Orion 8.5 PB: Bars automation issueThanks for report. It is fixed in next release in the following way:
Please note also that in step mode non drawn event's ranges will be empty.
4 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 137 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |