You cannot move notes from outside a bar / pattern, back into the pattern without expanding the pattern length first, eg:
If you record a pattern with any length (say 32), with notes in bars 17 - 32, then change then length to 16, you cannot move everything from bars 17-32 back to 1-16 using the Select tool in Pattern mode, without keeping the pattern at full length (32).
Pattern length problemModerators: Christophe, Mark
4 posts
• Page 1 of 1
Re: Pattern length problemConfirmed. The obvious workaround would be to keep the pattern at 32 , lasso and delete the notes in bars 1-16 then lasso and move the notes from bars 17-32 into 1-16, then change the pattern length to 16.
Re: Pattern length problemThat is correct.
I believe Richard confirmed somewhere that this was correct behaviour. Cheers ---=u f o=--- /Radiation Mutant / Snee-Nee-Iq
Re: Pattern length problemPlease refer to the topic:
viewtopic.php?f=1&t=9104
4 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 437 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |