All Cubase versions
Win 7 64bit
Legend 1.31 BlacklistedModerators: Christophe, Mark
5 posts
• Page 1 of 1
Re: Legend 1.31 BlacklistedWe need a few more details here.
Did you see any error message? Is this a fresh installation or an update on top of an existing installation? Did you rescan your VST Plugins in Cubase? Has The Legend been activated properly (note you can activate The Legend manually under Windows by launching Activation.exe, located in the folder "Documents\Synapse Audio\Legend", if in doubt). Admin - Synapse Audio Software
Twitter - www.twitter.com/SynapseAudio Facebook - www.facebook.com/SynapseAudioOfficial
Re: Legend 1.31 BlacklistedIt was authorized and working as of 1.30. Its the LegendFX than is blacklisted permanently and Legend available in Cubase 9.5 and up but it never loads. Earlier Cubase versions have LegendFX and Legend blacklisted
Re: Legend 1.31 BlacklistedHm it sure works all fine here in Cubase.
Do you have Windows 7 SP1 installed? This is the minimum OS version required for current and future builds (while TL does contain a 32-bit legacy build that still runs under Windows XP, any other version requires Win 7 SP1 or higher). Admin - Synapse Audio Software
Twitter - www.twitter.com/SynapseAudio Facebook - www.facebook.com/SynapseAudioOfficial
Re: Legend 1.31 BlacklistedYes on SP1 install.
Legend loaded is authorized and working under 9.5, 10.0, 10.5. The problem is LegendFX, which fails any attempt to get off the Blacklist.
5 posts
• Page 1 of 1
Who is onlineUsers browsing this forum: No registered users and 397 guests |
© 2017 Synapse Audio Software. All Rights Reserved. |